Chassis for 1/24 made of high quality 1.5mm stainless steel.
It includes..:
Front end made of carbon fiber (Assembled and with all the screws for adjustment, suspension springs and PKS-606 bearing carrier)
“H” for body tilting with 4 points for adjustment.
Engine and rear axle mounts “Offset 1.5mm.” (Mounted)
Small subframe (If you want to remove it, the engine will be flush) (Note: It depends on the regulations of each club)
Minimum axle distance 88/89mm.
Universal body anchors, with three holes to accommodate narrower bodywork.
2 gauges for the rear bridge 0.22mm and 0.50mm.
